偷窥国产综合_天天干天天色综合_蜜桃视频成人A片免费观看少妃_16p亚洲 - 亚洲国产综合在线观看不卡

ASTM D6113 用錐形量熱計對電纜或光纜中絕緣材料的著火試驗反應特性測定的標準試驗方法
ASTM D6113 Standard Test Method for Using a Cone Calorimeter to Determine Fire-Test-Response Characteristics of Insulating Materials Contained in Electrical or Optical Fiber Cables

ISO 5660, ASTM E1354, ASTM E1474, ASTM E1740, ASTM F1550, ASTM D6113, NFPA 264, CAN ULC 135, BS 476 Part 15
The Cone Calorimeter is the most significant bench scale instrument in the field of fire testing.Heat release is the key measurement required to assess the fire development of materials and products.

1. ASTM D6113電線電纜錐形量熱計－Scope

1.1 This is a fire-test-response standard.

1.2 Several fire-test-response characteristics, including the time to sustained flaming, heat release rate, total heat released, effective heat of combustion, and specific extinction area; are measured or calculated by this test method at a constant radiant heat flux. For specific limitations see also 5.7 and Section 6.

1.3 The tests are conducted by burning the electrical insulating materials contained in electrical or optical fiber cables when the cable test specimens, excluding accessories, are subjected to radiant heat.

1.4 The values stated in SI units are to be regarded as the standard. The values given in parentheses are for information only.

1.5 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety, health, and environmental practices and determine the applicability of regulatory limitations prior to use. For specific precautionary statements, see Section 7.

1.6 This standard measures and describes the response of materials, products, or assemblies to heat and flame under controlled conditions, but does not by itself incorporate all factors required for fire hazard or fire risk assessment of the materials, products or assemblies under actual fire conditions.

1.7 Fire testing is inherently hazardous. Adequate safeguards for personnel and property shall be employed in conducting these tests.

1.8 This international standard was developed in accordance with internationally recognized principles on standardization established in the Decision on Principles for the Development of International Standards, Guides and Recommendations issued by the World Trade Organization Technical Barriers to Trade (TBT) Committee.

ASTM D6113熱速放速率測試
ISO 5660-1 https://www.fire-test.cn/newsinfo/2144910.html
ASTM E1354 https://www.fire-test.cn/newsinfo/2150848.html

南京睿督公司全國免費咨詢電話：025-8658 3475   400-603-6575
網址：www.fire-test.com    www.fire-test.cn
郵箱：info@fire-test.com  
...